Files
tpms-schrader-eg53ma4-sim/docs/SAFETY.md
T
czcionka e183d23950
check / check-without-hardware (push) Successful in 6m45s
Docs and code: translate Polish comments, messages and documentation to English
- README, CHANGELOG, RELEASE_NOTES, THIRD_PARTY_NOTICES and docs/*.md
  translated to English; cross-markdown anchors updated
- C/C++/Python/shell comments and user-facing messages translated
- identifiers, protocol names, commands and literals unchanged
- native tests re-verified: 24/24 PASS; tpms_frame.py self-test PASS
2026-10-30 18:01:32 +00:00

48 lines
2.2 KiB
Markdown
Raw Blame History

This file contains ambiguous Unicode characters
This file contains Unicode characters that might be confused with other characters. If you think that this is intentional, you can safely ignore this warning. Use the Escape button to reveal them.
# Safety and limitations
## Synthetic data can hide a fault
This device generates data it does not measure in the tyres. The default
260 kPa is a test value, not confirmation of pressure. The simulator may cause
the warning light not to alert about a real puncture, pressure loss or tyre
damage.
- A diagnostic and workshop project only, on a parked car and under the
control of the person running the test.
- It is not a homologated sensor nor a replacement for a working TPMS.
- Do not use while driving and do not present it as safe for that purpose.
- Before and after the test, check all tyres with an independent gauge and
inspect their condition.
- After the diagnosis, restore working, correctly matched sensors and perform
the vehicle's required procedure.
## Radio and vehicle compatibility
The EG53MA4/OOK 433.92 MHz profile is a working hypothesis for the vehicle
indicated, to be confirmed. OE 13506028, a related part number, or a
replacement offer is not enough. Use the VIN, factory sensor markings,
diagnostics, or a controlled test. Do not transmit at maximum power "to be
sure". Start at −10 dBm, limit transmission time, and follow local 433 MHz
regulations and rules about interfering with vehicle electronics. The device
may be received by other receivers nearby.
## Installation
- Only the laboratory prototype is described as ready to assemble. The 12 V
version requires a separate design and automotive tests.
- Do not apply 12 V to GPIO/ADC or 5 V to the CC1101.
- Do not place the device near airbags, pedals, moving parts, moisture, high
temperature, or the LPG installation.
- Secure the enclosure and cables against loosening. Avoid shielding the
antenna.
- Do not use an 18650 cell as the recommended power source in the cabin.
## Diagnostics without false confidence
Correct decoding by rtl_433 does not prove reception by the car. Green CI does
not replace a CC1101 measurement, an HIL test, or a tyre check. The warning
light going out also does not prove the tyres are sound. Record measurements
and do not change several parameters at once. There is no confirmed low
battery bit of the sensor; low emulator supply is not encoded as a fault of
the simulated sensor.