- README, CHANGELOG, RELEASE_NOTES, THIRD_PARTY_NOTICES and docs/*.md translated to English; cross-markdown anchors updated - C/C++/Python/shell comments and user-facing messages translated - identifiers, protocol names, commands and literals unchanged - native tests re-verified: 24/24 PASS; tpms_frame.py self-test PASS
2.2 KiB
Safety and limitations
Synthetic data can hide a fault
This device generates data it does not measure in the tyres. The default 260 kPa is a test value, not confirmation of pressure. The simulator may cause the warning light not to alert about a real puncture, pressure loss or tyre damage.
- A diagnostic and workshop project only, on a parked car and under the control of the person running the test.
- It is not a homologated sensor nor a replacement for a working TPMS.
- Do not use while driving and do not present it as safe for that purpose.
- Before and after the test, check all tyres with an independent gauge and inspect their condition.
- After the diagnosis, restore working, correctly matched sensors and perform the vehicle's required procedure.
Radio and vehicle compatibility
The EG53MA4/OOK 433.92 MHz profile is a working hypothesis for the vehicle indicated, to be confirmed. OE 13506028, a related part number, or a replacement offer is not enough. Use the VIN, factory sensor markings, diagnostics, or a controlled test. Do not transmit at maximum power "to be sure". Start at −10 dBm, limit transmission time, and follow local 433 MHz regulations and rules about interfering with vehicle electronics. The device may be received by other receivers nearby.
Installation
- Only the laboratory prototype is described as ready to assemble. The 12 V version requires a separate design and automotive tests.
- Do not apply 12 V to GPIO/ADC or 5 V to the CC1101.
- Do not place the device near airbags, pedals, moving parts, moisture, high temperature, or the LPG installation.
- Secure the enclosure and cables against loosening. Avoid shielding the antenna.
- Do not use an 18650 cell as the recommended power source in the cabin.
Diagnostics without false confidence
Correct decoding by rtl_433 does not prove reception by the car. Green CI does not replace a CC1101 measurement, an HIL test, or a tyre check. The warning light going out also does not prove the tyres are sound. Record measurements and do not change several parameters at once. There is no confirmed low battery bit of the sensor; low emulator supply is not encoded as a fault of the simulated sensor.