check / check-without-hardware (push) Successful in 6m45s
- README, CHANGELOG, RELEASE_NOTES, THIRD_PARTY_NOTICES and docs/*.md translated to English; cross-markdown anchors updated - C/C++/Python/shell comments and user-facing messages translated - identifiers, protocol names, commands and literals unchanged - native tests re-verified: 24/24 PASS; tpms_frame.py self-test PASS
3.7 KiB
3.7 KiB
Troubleshooting
Work one change at a time and record the measurement. Do not switch OOK/FSK, flags, IDs, or intervals randomly. The base firmware has no FSK mode.
| Symptom | Possible cause | Measurement / check | Repair |
|---|---|---|---|
ERROR: no CC1101 |
poor supply, CS/SPI, module is not 433 MHz | 3.3 V across VCC-GND; continuity SCK/MISO/MOSI/CS = 4/5/6/7; module marking | fix wiring, shorten SPI, use the correct module |
| Reset during TX | 3.3 V droop, weak wires | voltage at the ESP32/CC1101 during send, brownout log |
fix the supply and 47–100 µF at the module; do not raise the PA |
TX-ERR |
underflow, unfinished TX, wrong CC1101 configuration | log for each wheel; MARCSTATE/registers in HIL | check SPI and supply; save the log for analysis, do not mask the error |
| USB/UART does not respond | console window too short, wrong baud/port, charge-only cable | 115200 8N1, reset, correct /dev/ttyACM* or /dev/ttyUSB* |
type stay 300 right after startup; use a data cable |
| ID change disappears | NVS write error, full flash | OK: saved message, restart and info |
do not continue on an NVS error; check flash/supply |
| ID rejected | duplicate, 0, FFFFFF, wrong length | six hex digits and info |
transmit four unique IDs from 000001–FFFFFE |
| rtl_433 decodes nothing | antenna, frequency, wrong RF path, too little power | send 1; 433.92 MHz receiver close by; ANT/GDO0 measurement |
fix antenna/supply; step through low powers gradually; do not switch to FSK |
| rtl_433 sees wrong data | stale configuration, neighbouring sensor | info, hex 1, ID filtering in the receiver |
compare IDs and force send 1 in an isolated spot |
| Car does not see known IDs | unconfirmed profile, ECU requires learning, range | VIN/markings/DTC; RTL-SDR reception at the car | confirm the profile; perform LEARN; change position after measuring |
| LEARN stuck on one wheel | used send instead of next |
info shows the active wheel |
next after confirming the step; send only forces TX |
| LEARN returned to NORMAL | 60 s per wheel / 15 min session | elapsed time, message and LED | run mode learn 1 and consciously repeat from FL |
| After RL there is no next wheel | the sequence completed | NORMAL in info |
finish the car procedure and check DTC |
| Warning light stays on although RTL-SDR is OK | ECU does not know the IDs, other profile/flags/procedure | read IDs and DTC from diagnostics, not only SDR | Clone IDs or LEARN; confirm the car profile; do not guess flags |
| High sleep consumption | S2 Mini, LM317T, LED, dividers | measure the whole board and regulator per POWER.md |
fix the supply; do not change the protocol |
| No TX after parking | supply only from the lighter socket/ACC, brownout, NVS/CC1101 error | does 3.3 V remain after the ignition goes off; log after restart, batt, info |
with an ignition-switched socket supply the lack of TX is expected; otherwise fix the supply |
| ACC does not change the interval | feature disabled by default or wrong threshold | PIN_ACC, voltage on GPIO OFF/ON |
build a protected input; never 12 V on GPIO |
When the car does not receive
Diagnostic sequence:
- Prove local TX:
send 1+ RTL-SDR/analyser. - Prove the correct profile: VIN, sensor markings, car readout.
- Check IDs and order:
info, Clone IDs, or one active wheel in LEARN. - Check range: low power first, console/behind the glovebox, possibly the boot; without disassembling airbags or guessing the ECU location.
- Only then analyse flags: compare with a recording of the original sensor in the same mode. There is no confirmed low-battery bit — do not set it.
- If there is no measurement or data, stop the test. Random changes add new variables and are not a diagnosis.