# TPMS EG53MA4 Simulator 2.0.0-rc.1 **Release candidate — 2026-10-27. This is not a "validated" release.** A diagnostic simulator of four Schrader EG53MA4 sensors for the ESP32-S2-MINI (ESP32-S2FN4R2) + CC1101 433 MHz with an SMA antenna. The target profile includes tests with an Opel Astra J Sedan 2016, but compatibility of the specific car must be confirmed. Synthetic data can hide a tyre fault; do not use while driving. ## Features - four persistent, independent 24-bit IDs; 260 kPa by default for every wheel; - OOK/Manchester 433.92 MHz, low configurable power from −10 dBm; - Clone IDs and New IDs + LEARN FL→FR→RR→RL, SINGLE/diagnostics; - NVS configuration over UART without recompilation, version/CRC/ validation/factory reset; - button, LED, timeouts, deep sleep with RTC and optional hardware ACC; - automated native/RF/build tests, Docker, and SHA-256 artifacts. ## Required hardware ESP32-S2-MINI (ESP32-S2FN4R2), a CC1101 **433 MHz** 3.3 V module with an SMA connector (e.g. ARD-CC1101-ANT), an antenna, a button, and decoupling. The LED is built in. Target power from the cigarette-lighter socket: a car USB charger or an LM317T with a 240/390 Ω divider and proper capacitors; the 12 V variant requires input protection and tests. Full BOM/pinout: HARDWARE. Neither the S2 Mini nor the LM317T is a validated automotive solution on its own. ## Installation and update New installation: `bash tools/check_all`, then `pio run -e esp32s2mini -t upload`. Release images: `bash tools/package_release.sh`; addresses and flashing are described in VALIDATION. Before a full flash, write down your IDs — the NVS partition may be erased. Verify the configuration after a restart with `info`. There is no migration from version 1.0 without NVS; enter the IDs in the console once. ## Test results without hardware (2026-10-28) - native: 24/24 PASS (after the hardware–firmware integration audit); - full ESP32 build with `-Werror`: PASS; - cppcheck: PASS, 0 defects; - rtl_433: 64/64 reference records, 3/3 synthetic, 3/3 negative: PASS. Exact commands and pinned commits: VALIDATION/PROTOCOL. ## Known limitations - The real CC1101 emission, tail, power, and frequency were not measured. - RTL-SDR with an antenna, consumption measurement, brownout, and the ACC test were not performed. - Clone IDs/LEARN with a car were not performed; OE 13506028 was not confirmed for a specific VIN. - The meaning of all flags remains unknown; there is no guessed low-battery bit. - The schedule is experimental, not confirmed as OE. - The LM317T and power from the cigarette-lighter socket are not a validated automotive design; with power only from an ignition-switched socket there is no transmission after the ignition goes off — the car ECU does not listen then anyway. - Gitea Actions requires a working runner; local results do not mean CI PASS. Until the HIL items in VALIDATION are checked off, the result remains a release candidate.